1974 20' sceptre transom replacement and i/o to outboard bracket conversion

[flyingfrizzle]

Once the core was dry I added my final layers of glass, a combination of 1708 and matt. Around the edges I added several layers of glass to make the edges one inch thick so I would have some meat to cut a vee in when I glass it in the boat. Here is the hole that it will be filled by this blank. It will be epoxied in place onto the stringers and then a vee ground on the edges and glassed to the original deck:

[Bushwacker]

Friz,

Nice work - should be a sharp looking rig! Ever thought about putting hinges on that board and making a hatch out of it where the old engine box was? Seems like that might make a handy storage space under the deck?

[flyingfrizzle]

Quote"Nice work - should be a sharp looking rig! Ever thought about putting hinges on that board and making a hatch out of it where the old engine box was? Seems like that might make a handy storage space under the deck?"

It is fully glassed in now at this point but I made it beefy so that I can cut an access hole in the floor panel and it will be plenty strong even with a hatch cut into it. I more than likely will make a hatch for it, but not sure yet. I have a nice new abs plastic o-ring sealed factory made add on hatch that came with the master angler that was never used but think I rather make a custom fiberglass one.

[flyingfrizzle]

Here are a few pic's of the rear liner/cap coming back together:










Here is a few Pics of the fuel cover getting a new coring: