1970 Seafari conversion to CC

[afishin82]

Originally Posted by NoBones

Andre...
Looks great, but you have no excuse for not showing up, living 4 blocks from
all of us being at the Sportsmens Lodge and Ferndale Lodge
at this weekends gathering ....

You missed some great chow last night..

I was almost gonna come hunt you down!!

Wish I had know you were here! You should have hunted me down!!!

[DonV]

Damn Bones, I guess that "gathering" section on our forum is too tricky. We need to get our moderator, "crash" Danny, to work on simplification!!

[afishin82]

Originally Posted by DonV

Damn Bones, I guess that "gathering" section on our forum is too tricky. We need to get our moderator, "crash" Danny, to work on simplification!!

Didn't even know there was a gathering section

[Capt Chuck]

Just a thought here
It appears those vertical rod holders / cap supports are going to be real "Toe Catchers" and also block water washdown flow.
They don't need to tab too the deck. I would reconfigure them

BTW: Great Job!

[afishin82]

Originally Posted by Capt Chuck

Just a thought here
It appears those vertical rod holders / cap supports are going to be real "Toe Catchers" and also block water washdown flow.
They don't need to tab too the deck. I would reconfigure them

BTW: Great Job!

The boxes on the sides are for support and one side is for my fuel fill and vent. I wish I didn't need them but I do. I'm sure my toes are gonna hate me for it at some point. Drunk friends at the sandbar are gonna hate it even more!

[flyingfrizzle]

This is what you need to spray the gel, no thinning needed. Still will require sanding but not as much as rolling. You can thin it and spray threw a gun with a big tip and get good results but it can be tricky. The gel gun works well and don't take much training to use it. Best thing is it cleans up in seconds, you just throw the cup away and clean the tip orifice and you done.

[afishin82]

Originally Posted by flyingfrizzle

This is what you need to spray the gel, no thinning needed. Still will require sanding but not as much as rolling. You can thin it and spray threw a gun with a big tip and get good results but it can be tricky. The gel gun works well and don't take much training to use it. Best thing is it cleans up in seconds, you just throw the cup away and clean the tip orifice and you done.
Attachment 10349

So how do you deal with the pinholes? Prime it first?

[DonV]

http://www.classicseacraft.com/commu...isplay.php?f=3

Here ya go, notice there are some other sections with good info and advice, including the gathering section!! Your boat is looking real nice, you are really on your way to a sweet ride. Good luck!

[afishin82]

Originally Posted by DonV

http://www.classicseacraft.com/commu...isplay.php?f=3

Here ya go, notice there are some other sections with good info and advice, including the gathering section!! Your boat is looking real nice, you are really on your way to a sweet ride. Good luck!

Thanks Don! It's gonna be so much sweeter once I get that hermco bracket hanging on the stern!