I'm almost finished with my 20

[sidelock]

Why did you raise the transom to 26.5", will it still be able accommodate a 25" shaft O/B ?

[bibijawa]

Yeah, I raised it. I've measured and the cavitation plate will end up right where it should be.

[bibijawa]

Installed the cleats and rodholders. Also recut scupper holes.

[bibijawa]

I'm having trouble finding two extra long stainless thru hull fittings in 1 1/8". The standard length from attwood is to short for my transom and I just bought some off Amazon that have a 1 1/8" barb but the thread is 1 1/2". I don't want to cut a hole that big in the transom if I don't have to. I can find the right length in plastic but I prefer stainless. Can someone recommend a shop or website where I can order these.

[bibijawa]

I finally finished. I took her out for a test ride on Sunday.[URL=http://s1140.photobucket.com/user/bibijawa/media/Mobile%20Uploads/20160417_174502.jpg.html][/URL]

[Old'sCool]

Originally Posted by bibijawa

I'm having trouble finding two extra long stainless thru hull fittings in 1 1/8". The standard length from attwood is to short for my transom and I just bought some off Amazon that have a 1 1/8" barb but the thread is 1 1/2". I don't want to cut a hole that big in the transom if I don't have to. I can find the right length in plastic but I prefer stainless. Can someone recommend a shop or website where I can order these.

Gemlux should have them http://www.gemlux.com/

[bibijawa]

I was able to find extra long 1 1/8" fittings that o finally installed.