![]() |
|
#1
|
||||
|
||||
![]()
That Resin Dispenser deserves the "Gucci Stamp" Award
![]() Spidercrab would be proud of you .........
__________________
![]() ![]() 1978 23' Superfish/Potter Bracket 250HP -------- as "Americans" you have the right to ...... "LIFE, LIBERTY and the PURSUIT of a Classic SeaCraft" -capt_chuck |
#2
|
|||
|
|||
![]()
Only got one of the boards skin coated on one side. This is a two inch foam board intended to raise the stringers. I used peel ply and a six inch roller to force out excess resin.
Question is there a better way to remove excess resin other than vacuum bagging? |
#3
|
|||
|
|||
![]()
Tried a nida board with and w/out peel ply and I believe the results are the same. Went with a 6" roller to move the resin around then to a 4" spreader to remove excess resin then back to the 6" roller to lay it out smooth.
This is all new to me, the biggest board I've done in the past was 28X60". Already getting more confidence as I go. Received the MOB yesterday. Found it on THT good deals thread w/discount code. Will be especially nice on the long hauls. |
#4
|
|||
|
|||
![]()
The resin pump was a flop, seems the resin and pump seals do not play well together. It froze up.
|
#5
|
|||
|
|||
![]()
Well that's a bummer! Being sensitized to epoxy I had high hopes. It was a nice try though
![]()
__________________
The older I get the faster I was! |
![]() |
|
|