floor drains..Two questions

[davids495]

Thanks for the reply. I did think about raising the deck but decided against it as I wanted to use the inner skin. Now the core is down and I don't want to go backwards. Have I backed myself into a corner?

[Capt Chuck]

Originally Posted by davids495

Thanks for the reply. I did think about raising the deck but decided against it as I wanted to use the inner skin. Now the core is down and I don't want to go backwards. Have I backed myself into a corner?

You can use Carl's answer to wet feet by closing off the existing thru hull floor drains and then putting in an elbow floor drain , then install PVC tubes crossing them out thru the transom with flapper type scuppers

ex: Port floor drain over to the starboard side scupper thru the transom & starboard floor drain over to the port side scupper thru the transom

[davids495]

Nice Graphic Captain Chuck!

I did a search for Carl's wet feet solution but didn't come up with anything. Can you point me to the thread?

Am I correct that you are suggesting I patch over the current drains as they come out through the bottom of the hull and then just below the floor, cut the down tube and put an elbow into it so it goes aft. Then run tubing to flaps out through the transom on the opposite side of the boat?

Are the current flood drains typically above or below the waterline when the boat is at rest with no one aboard?

[caper]

I had '75 20SF with a 2003 Johnson 175 2 stroke at 385 lbs. - batteries & oil tank under the console and the 47 gallon aluminum fuel tank pushed forward as far as it would go. Kept the boat on moorings or wet slipped and never had an issue with the through the floor drains. I did always keep the in the floor livewell drain plugged when I left the boat for a few days. My drains were about 1" above water when the boat was at rest with a full tank.

[Capt Chuck]

Originally Posted by davids495

Nice Graphic Captain Chuck!

I did a search for Carl's wet feet solution but didn't come up with anything. Can you point me to the thread?

Am I correct that you are suggesting I patch over the current drains as they come out through the bottom of the hull and then just below the floor, cut the down tube and put an elbow into it so it goes aft. Then run tubing to flaps out through the transom on the opposite side of the boat?

Are the current flood drains typically above or below the waterline when the boat is at rest with no one aboard?

Yes, plug existing thru hull drains.
if you search "scuppers" or "floor" drains you will come up with more reads than Hillary's emails. I don't remember as I had a 23'. so you need to filter them some how to see solutions / pictures from other members who have a 20
footer that have changed their scupper config to a suitable solution.
Someone help here like "NoBones" please

[rcnight]

I have an older 150 Evinrude on back of mine and use the cross-over to opposite sides and it keeps me pretty dry. Not sure how well it works letting water out. How bout an automatic bilge pump in your baitwell - sort of like a sump pump.