|
|
|
|
#1
04-05-2021, 10:45 PM
|
|||
|
|||
I have seen pictures on here of the molded splashwell if that is what you are talking about. Do a search for that or just a google search for 18 Seacraft and I bet you will see that. Mine had a glassed-in version of that when the previous owner ran scuppers through the bottom of the hull. It would fill if you stood in the corners. I tore that out and ran them out through the transom like original. I put a lot of time into restoring the gutters and reworking that detail. I pitched the inside of the motor well to eliminate standing water and will still put ping pong balls or flaps this spring.
|
|
#2
04-05-2021, 10:54 PM
|
|||
|
|||
|
One more. Original gutter exits where circled. 9 or 10” splash board is new obviously. You can see the old holes in the outside corner. I think the splashwell part you mention was an option from the factory. Someone correct me if I am wrong.
|
|
#4
04-06-2021, 07:07 AM
|
|||
|
|||
|
Thank you. Transom was raised to 26.5” and I will measure the splash board. Had to guess a little and was happy I didn’t need to cut it after glass/fairing/paint. Probably could have gone higher but need to see how cables and harness land when tilted.
|
|
#5
04-06-2021, 12:20 PM
|
|||
|
|||
|
__________________
1975 SF18/ 2002 DF140 1972 15' MonArk/ 1972 Merc 50 http://i833.photobucket.com/albums/z...photos/SC3.jpg
|
 |
|
|
Hybrid Mode
