Stainless marine o\b bracket

[mazz888]

I am around 5600-5700 with motor trimmed out (not sure of the trim %)

The AV plate is around 5.5-6in from the keel, it was a little hard to measure alone. Here is a shot of the set up. I already removed the transducer to see if that was causing bad water into the prop. I don't know if the tabs are the issue they had to be moved in closer to the engine to fit when the bracket was first installed. I am thinking about moving them back to where the should be.


wattaway2 sorry for high jacking your thread.