|
|
|
|
#1
01-20-2022, 09:25 PM
|
|||
|
|||
Got the boat in the shop today. Took some initial measurements and started pulling off hardware I want to re use. See pic for measurements. Are there any other important dimensions I should take note of before I start cutting? Can anyone tell me if some of this hardware is original from the factory? They say Lee’s Miami on them.
|
|
#2
01-20-2022, 10:48 PM
|
|||
|
|||
|
Most of the original hardware was by Mardium for the haws pipes and cleats anyway I’m sure the outrigger holders at least would have been an option. With Lee’s being from Miami they would likely have sourced rod holders from them as they were quality pc’s then and today
|
 |
|
|
Hybrid Mode
