225 e tec

[wattaway2]

Originally Posted by 6buoys

Its a 2006 and i am thinking about a bracket also

That will shift the center even further back ( more of a lever) so get the largest tub you can (think twin engine type)and full swim platform as it will also help spread the load across the whole transom . I used 1/4” x 3” (4?)aluminum plate everywhere I could on my bracket getting at least 2 bolts min. Instead of individual washers again spreading the loads as much as possible . The cost was not really bad to speak of . All that being said there is a thread on the site with a 300hp with bracket on the back of a 20’