Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.
FAQ Community Calendar Today's Posts Search

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 06-23-2022, 09:49 PM
KenB KenB is offline
Senior Member
 
Join Date: Mar 2008
Posts: 298
Default livewell plumbed.

Plumbed the livewell. Groco seacock into seachest I molded up with my 'bracket' skills, male mold was a battery box. 1500 gph bilge pump to 1-1/8' 'fish pond' tubing. Overfill drain was mounted on top but doesn't drain so I will move it to the side. My hatch cover is leftover 1/4 lexan from the doghouse windows with a neoprene seal, but it flexes too much to provide enough of a seal to push water up the 2" elbow, probably need an Archimedes screws. Main drain is 1-1/2 pool tubing, works fine. I added a '30 sec on/3mins off' timer so I can use the 'aerate' switch on the dash.

If the headwinds are more than about 40 knots, overflow spray fills the doghouse, gotta fix that.

My dog lucyyy not impressed with the first pogie I cast netted. But who knew GSPs could point pogies. Top end with full gas and filled livewell dropped to about 30 knots. Still cruise at 4k rpm, 20 knots, 3 mpg. No one asked, but survey says... $63K.

Wins:
1) Boat didn't sink.
2) Pump works. Not too many leaks.
3) Pogies and scup not dead.
Attached Images
          
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:04 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft