|
|
#11
05-14-2011, 08:44 PM
|
|||
|
|||
Re: 1988 Yamaha 175, stainless prop, tilt/trim
In case 76seacraft passes on it...
Ran it today. Compression is less than stellar 80-110 PSI, depending on the cylinder. I have video of it running and the compression tests. I can offer it with a stainless prop and controls, and spare starter. Tilt trim works. Can ship from my loading dock. A gem? No. But probably good for a season, then a rebuild in the off season. Once again a '88 20" shaft motor. Make me an offer? I am pulling it next weekend. 
|
|
#12
06-02-2011, 01:13 AM
|
|||
|
|||
|
Re: 1988 Yamaha 175, stainless prop, tilt/trim
$999/ OBO. Or I can part it for TnT/Prop/Lower unit.
|
|
#13
06-20-2011, 10:08 AM
|
|||
|
|||
|
Re: 1988 Yamaha 175, stainless prop, tilt/trim
Sill for sale- BEST OFFER. Might part it for lower unit/ prop before I recycle it.
|
|
#14
07-04-2011, 10:23 PM
|
|||
|
|||
|
Re: 1988 Yamaha 175, stainless prop, tilt/trim
SOLD. compression tester was wrong. Apparently it has 120-140 PSI.Not bad for an '88!
|
|
#16
07-11-2011, 12:28 AM
|
|||
|
|||
|
Re: 1988 Yamaha 175, stainless prop, tilt/trim
My crap gauge. The local guy came over with his gauge. It hit from 115-140 on all 6 holes. Not super even, but not low, and consistent for the past few tests.
|
 |
|
|
Linear Mode
