I know I have seen the original transom layup discussed a number of times but I'm wondering if someone could check in on some specifics. Where my new transom core is at 26.5" from the keel and the original skin is at 20", what is the best sequence for infilling the 1/4" void in that 24" x 6.5" section? I have beveled back the skin beyond but should I just infill 4 or 5 l small layers to match exterior skin thickness and then wrap the full layers of 1708 through the cutout? Also, is two layers of 1708 adequate for the interior skin of my new core? Assuming 2" tab for first layer then 4" for second layer on to hull sides. Planning to clean up the bevel more beforehand and buildup in one shot if possible.
|
03-15-2019, 10:45 PM
Threaded Mode